Daniel Defense M4 V7 LW W/ Accessories

[ElPresidente]

Looking for $1,250 obo, no trades please.

Barely used, maybe 100 rounds fired and then put away when I was stationed in Japan for 3 years. EOTech will need new battery due to it being in storage.



http://imgur.com/a/Y23tF

Location: Phoenix

Bill of Sale and AZ ID required

LOWER RECEIVER: Mil-Spec with Enhanced Flared Magazine Well and Rear Receiver QD Swivel Attachment Point. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized


UPPER RECEIVER: Mil-Spec with Indexing Marks and M4 Feed Ramps. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized


BARREL: Chrome Moly Vanadium Steel, Cold Hammer Forged, 1:7 twist, 16″ Lightweight Profile, Mid-length Gas System, Chrome Lined, MP tested, and Mil-Spec Heavy Phosphate Coated


GAS SYSTEM: Pinned Low Profile Gas Block CNC Machined of 4140 hardened steel and Mil-Spec Heavy Phosphate Coating, Mid-length, Direct Impingement


MUZZLE DEVICE: Daniel Defense Flash Suppressor, 17-4 PH Stainless Steel, Salt Bath Nitride Finished


BOLT CARRIER GROUP: M16 Profile, Mil-Spec MP Tested, Chrome Lined, Properly Staked Gas Key


BUFFER: H Buffer


SIGHTS: EOTech 512 and Iron sights


HANDGUARD: Daniel Defense MFR XS 15.0, CNC Machined of 6061-T6 Aluminum, M-LOK Attachment, Type III Hard Coat Anodized


RECEIVER EXTENSION: 6 Position Mil-Spec 7075-T6 Aluminum


BUTTSTOCK: Daniel Defense Buttstock, Glass Filled Polymer with Soft Touch Overmolding


PISTOL GRIP: Daniel Defense Pistol Grip, Glass Filled Polymer with Soft Touch Overmolding

Soft case and ammo included.

[ElPresidente]

Back to the top

[ElPresidente]

Bump with price change.

[eblangfo]

how much would you sell w/ out the eotech?

[ElPresidente]

Sorry answered above question in a pm but the gun by itself is going for $1000 obo.

[ElPresidente]

Bumping back up to the top.

[ElPresidente]

Sending it back up.